How to fix C3451 error on Bizhub 250/350

How to Overcome Problem C3451 Bizhub 250/350 Copy - this problem often occurs when the machine has a problem with the heater. Starting from a dirty thermistor, unbalanced electrical power.  an error problem on a copy machine is an old problem. where the machine will stop working and not as usual. this will obviously interfere. as we will discuss about the C3451 solution on the Konica Minolta Bizhub 250/350 engine.

The first step before you repair the machine, it's good to make small steps first. ie reset Bizhub 250/350 by entering some code through the program. based on user experience, the C3451 problem can be overcome by resetting the 250/350 bizhub copy machine. if from a simple method cannot solve the problem of the error that occurred, you can take the next corrective action.

The C3451 problem is usually caused by unstable electric current, which results in the 250/350 bizhub engine issuing an error warning. in this case you must make sure you have used a stabilizer as a safety electric current in the copy machine section. Stabilizers used on Bizhub 350 photocopiers are of course many benefits, besides being the engine safety of unstable electric current. this method can also extend the life of the copy machine. so in this problem the use of stabilizers is important.

Read Also :
How to set up Konica Minolta Bizhub 250/350 as a printer and scanner
Fix LCD touchscreen photocopier Konica Minolta Bizhub doesn't work

Before we discuss more deeply, how to fix C3451 on a bizhub 350 photocopy machine. We will discuss the causes of this error. the C3451 problem is usually caused by a photocopy machine that is unstable, it may be damaged, the next is the problem with the thermistor part that has been damaged, and also the toner spill in the copper area which is located on the side door, close to the switch. how to fix it is:

• Make sure the copper plate switch on the side door is clean
• Check the thermistor section
• Use a stabilizer
• Check the bizhub 350/250 photocopier heater section

before the four steps above are done, you should overcome the problem of C3451, you can try resetting the machine, with the following steps:

• Press the small button on the LAN part using a screwdriver

  

  button circled in red

• The machine will restart
• after life there will be a dot, located next to the copy machine screen
  
• press number 3
• Enter the password for the bizhub 350/250 copy machine 12345678 or 00000000 press end
• it will enter reset mode

The above steps are done without having to dismantle the engine parts, it could be that your problem can be solved by resetting the bizhub 350/250 engine. without having to dismantle the engine parts. if there are shortcomings from this discussion, you can add some entries via the comment pool below. thank you for visiting the copytechno.com blog.

Share this post