How to Fix C2557 Konica Minolta Bizhub 250/350 Error
How to Fix C2557 Konica Minolta Bizhub 250/350 Error - Actually, the problem is Error C 2557 copy of Bizhub 250/350 is a classic problem, C 2557 often occurs in 250/350 types of Bizhub machines where this problem usually occurs because the toner runs out. so that between the developer powder/stater and the toner is not balanced. Before the Error C 2557 problem arises there is usually a warning about the toner running out but you ignore it. the improvement step is, of course, you have to reset the program part and balance the toner powder and the developer powder.
But sometimes, after balancing the toner and the developer, the problem still appears. it could be because the hopper cannot supply ink to the developing tube. this usually happens because the hopper foam is sticky. friends can be replaced by using black tape.
 |
| How to Fix C2557 Konica Minolta Bizhub 250/350 Error |
In Handling C 2557, a 250/28 Bizhub photocopy is indeed a problem that must be checked, if the tips described here have been done but the problem cannot be solved. the best step you should contact a technician.
Read Also :
Steps to Overcome C2557 Bizhub 250/350 copy
- Select PROGRAM (located at the bottom right of the touch screen)
- Select CHECK DETAIL (located at the bottom of the touch screen column)
- Press the Stop button on the right side above the Start button
- After that, please press 00
- Then you press the Stop button again
- If then press 01
- Enter the password with the following number 00000000
- Press the LEVEL HISTORY sign (see first comparison between ATDC SET and ATDC LEVEL / the point is that the ATDC level must be at a minimum of 4.5% and the maximum is 5.5% if the value is less than 4.5% it will often cause code error but if the value is excessive up to 6.5% and above, this can also cause an error code to appear, even if the error code does not come out, it is certain that the toner or photocopy ink will be wasteful and the results will be less than optimal.
- After that you press END
- Press TECH REP CHOICE Then press PRINTER
- Then press ATDC GAIN SENSOR (for example the number is 150 then raise / lower with the C Button and the value to be played from the button)
- After that, press the number you want manually, after clearing the number press END so that the number you have used was saved in the system
- If you press the END button until EXIT
- After that you will be able to copy 1 sheet, then check ATDC LEVEL again.
- I train you to do the opposite if you feel your machine is not normal. IMPROVE several times until ATDC LEVEL is completely normal.
- f the problem is still not finished, the problem is in the selenoid toner section in the machine, prepare a lot of time and a screwdriver to open this section, I suggest if you are still confused to dismantle the machine. caller technician, because many processes will be dismantled.
- Usually this problem is caused by sticky solenoid. because there is foam on the solenoid that must be replaced.
From the steps above, hopefully it can provide new lessons. how to discuss the Bizhub 250/350 C2557 engine. please if you want to add a comment.From the steps above, hopefully, it can provide new lessons. how to discuss the Bizhub 250/350 C2557 engine. if you want to add the contents of the comment field.
0 Response to "How to Fix C2557 Konica Minolta Bizhub 250/350 Error"
Post a Comment